SE128 MOUNTINGS
This range of mountings has one or two steel mounting plates depending on the model, one or several high strength steel springs, 2 light alloy rings and a stainless steel wire cushion in each spring.
This range of mountings has one or two steel mounting plates depending on the model, one or several high strength steel springs, 2 light alloy rings and a stainless steel wire cushion in each spring.
All steel parts are painted.
These very low frequency isolators (down to 3 Hz) can be used to mount machines rotating at speeds over 450 rpm, vibrators and impact machines, achieving an attenuation of about 95%.
They are all metal and can be used outdoors or in the harshest conditions.
As they do not creep, their life time may be the same as that of the machine they are used to mount.
A metal cushion inside each spring increases the damping factor and limits the amplification to a natural frequency.
Our range of acoustic foams can be ideally combined with the antivibratory properties of rubber mountings in order to reduce noise nuisance.
Bitumen heavy masses can also be used to stop the vibrations produced by thin sheets.
Our Super-Resilient material can be used as a supplement to disconnect conductive elements (slabs, rigid stands, pipings...). Made up of rubber particles that are linked between them, this flexible material benefits from the dampening properties of elastomers and is really good value for money.
- WEB TRUST SEAL delivered by CHAMBER TRUST INTERNATIONAL
The auto sealing damper support Red 15 GRIPSOL is recommended to install machines with medium tonnage such as: fans, pumps, cold groups, packaging machines, water pumps, lift machines...
The SE552 foam is an acoustic foam made up of Neoprene rubber and EPDM. Available in 2,000x1,000 mm plates, this foam can be produced in different thicknesses from 2 up to 50 mm (recommended thicknesses for soundproofing : 20, 25, 30 ou 40 mm).
The heavy mass range is made up of viscoelastic bitumen that is used to deaden vibrations and provision of mass, both in the building sector and in the industrial environment.
The SE131 mountings steel have a mounting plate, cover and swaged teel shaft. This mouting is available with stainless steel or mild steel zinc plated metalwork. The resilient parts are stainless steel wire cushions. The steel parts are zinc plated.
Standard SE121 mountings have a cast steel base and a resilient element made from a stainless steel wire cushion.
Low profile mountings with high static and dynamic load range : 100% 316 stainless steel Natural frequency from 15 to 18 Hz Dynamic load in compression : 3 g
