SE124 MOUNTINGS
The SE124 dampers have a cover, an AG3 mounting plate and an AU4G shaft. The assembly is chromatised.
The upper and lower stainless steel cushions are the resilient elements of the mounting. It has four Ø 8 mounting holes on the mounting plate and one M10 tapped hole on the upper cover.
The SE124 dampers have a cover, an AG3 mounting plate and an AU4G shaft. The assembly is chromatised.
The upper and lower stainless steel cushions are the resilient elements of the mounting. It has four Ø 8 mounting holes on the mounting plate and one M10 tapped hole on the upper cover.
The load range of between 5 and 170 kg makes it suitable for isolating light machine tools from motors with rotational speeds of over 2,500 rpm.
The V164 has an isometric natural frequency of 15 to 22 Hz and 8 to 12 Hz. Their lower cushion can withstand accidental traction forces (for example, shock rebound).
These dampers are not affected by aggressive chemicals and can be used, for example, for mounting petro-chemical pumps.
Our range of acoustic foams can be ideally combined with the antivibratory properties of rubber mountings in order to reduce noise nuisance.
Bitumen heavy masses can also be used to stop the vibrations produced by thin sheets.
Our Super-Resilient material can be used as a supplement to disconnect conductive elements (slabs, rigid stands, pipings...). Made up of rubber particles that are linked between them, this flexible material benefits from the dampening properties of elastomers and is really good value for money.
- WEB TRUST SEAL delivered by CHAMBER TRUST INTERNATIONAL
The Purple 20 Gripsol antivibratory plate is noted for its specific polymer that gives it a high dampening power on a wide frequency spectrum.
The polyurethane has remarkable properties for the industrial environment: Great abrasion resistance. Great cutting resistance. Dampening material.
The heavy mass range is made up of viscoelastic bitumen that is used to deaden vibrations and provision of mass, both in the building sector and in the industrial environment.
Standard SE121 mountings have a cast steel base and a resilient element made from a stainless steel wire cushion.
The SE120 mount is made of a round metal cushion covered with an anti-slip elastomer pad on both side.
Low profile mountings with high static and dynamic load range : 100% 316 stainless steel Natural frequency from 15 to 18 Hz Dynamic load in compression : 3 g
Machine mount available with a stud or threaded hole. Top cup and stud are mild steel zinc plated. Stainless steel wire mesh cushion. Natural frequency between 15 to 20 Hz.