Pompes

SE110 MOUNTINGS

The SE110 is a remarkable antivibratory product : Better than 90% insulation at 1.500 rpm (25 Hz). Constant height over wide load range. Stabilised characteristics during Service Life.

SE111 MOUNTINGS

The design of the SE111 mounting gives the following basic characteristics : Radial elasticity greater than axial elasticity The rubber works in compression (axial), shear (radial), compression/shear according to the fixing method

SE131 MOUNTINGS

The SE131 mountings steel have a mounting plate, cover and swaged teel shaft. This mouting is available with stainless steel or mild steel zinc plated metalwork. The resilient parts are stainless steel wire cushions. The steel parts are zinc plated.

SE115 MOUNTINGS

The SE115 mounting comprises a conical rubber section bonded between inner and outer metal parts. Centre axis with threaded hole. Square (4 holes) or diamond base (2 holes) with clearance hole.

SE117 MOUNTINGS

The SE117 mounting comprises one piece elastomer bonded to a top and bottom plate.

SE132 MOUNTINGS

Low frequency high deflection antivibration mounting available in a choice of elastomers including high damped silicone.

Supports Paulstraflot

SE150 Elastic couplings

The SE150 coupling is designed with the following features : Push fit assembly Compact, smooth cylindrical shape without protrusions The flexible element is precompressed during assembly, which extends the range of operating conditions where the rubber is not subject to tension

SE153 Elastic couplings

Flexible element : Metallic bobbins linked together by rayon fibres ­The whole unit is potted in natural rubber and is hexagonal

SE151 Elastic couplings

There are two variations of the SE151 coupling : hollow hub and solid hub : Flexible element : Formed of solid natural rubber ­External steel surround, bonded to the rubber

SE154 Elastic couplings

Flexible element : Precompressed natural rubber ­Bonded metal reinforcing mountings Precompression band (to be removed after installation)

SE155 Elastic couplings

Flexible element made up of a variable number of flexible studs depending on the torque to be transmitted : ­Solid natural rubber blocks in the form of a truncated cone Internal armature bonded to the rubber

SE124 MOUNTINGS

The SE124 dampers have a cover, an AG3 mounting plate and an AU4G shaft. The assembly is chromatised. The upper and lower stainless steel cushions are the resilient elements of the mounting. It has four Ø 8 mounting holes on the mounting plate and one M10 tapped hole on the upper cover.

SE128 MOUNTINGS

This range of mountings has one or two steel mounting plates depending on the model, one or several high strength steel springs, 2 light alloy rings and a stainless steel wire cushion in each spring.

SE126 MOUNTINGS

The SE126 range has a pressed steel casing and mounting plate and light alloy shaft. The resilient element is a stainless steel wire pad.

SE111B MOUNTINGS

The design of the SE111B elastic stops gives the following basic characteristics : Highly deformable, allowing high energies to be absorbed. Progressive absorption of energy due to the carefully designed shape.