Ventilateurs

The SE110 is a remarkable antivibratory product : Better than 90% insulation at 1.500 rpm (25 Hz). Constant height over wide load range. Stabilised characteristics during Service Life.

The design of the SE111 mounting gives the following basic characteristics : Radial elasticity greater than axial elasticity The rubber works in compression (axial), shear (radial), compression/shear according to the fixing method

The design of the SE111B elastic stops gives the following basic characteristics : Highly deformable, allowing high energies to be absorbed. Progressive absorption of energy due to the carefully designed shape.

The SE116 is a revolutionary rubber support. It is formed from two thick conical membranes, joined at their bases to create a highly elastic mounting.

he SE114 mounting comprises one or more layers of elastomer bonded to flat, parallel metallic plates. These mountings may be cylindrical or rectangular. They are designed to withstand very high compressive loads. The range of mechanical characteristics is governed by the hardness of the rubber and the number of intermediate metallic plates.

The SE115 mounting comprises a conical rubber section bonded between inner and outer metal parts. Centre axis with threaded hole. Square (4 holes) or diamond base (2 holes) with clearance hole.

The SE118 mounting comprises an annular section bonded between the inner tube and outer housing. The outer housing has a mounting flange (4 different types).

The SE130 mounting comprises a rubber ring bonded to a central tube. Inner tube : mild steel Bonded rubber in the form of a ring at the top with a collar below which is used for fixing

The SE220 mount is made of two parts of elastomer bonded to a central tube.   Interior reinforced: cylindrical tube.   Elastomer: chloroprene. Range of five different stiffnesses

A flexible fixing resistant to oils, the majority of solvents and ageing

The SE117 mounting comprises one piece elastomer bonded to a top and bottom plate.

The SE120 mount is made of a round metal cushion covered with an anti-slip elastomer pad on both side.

The SE131 mountings steel have a mounting plate, cover and swaged teel shaft. This mouting is available with stainless steel or mild steel zinc plated metalwork. The resilient parts are stainless steel wire cushions. The steel parts are zinc plated.

This range of mountings has one or two steel mounting plates depending on the model, one or several high strength steel springs, 2 light alloy rings and a stainless steel wire cushion in each spring.